DC 2000
Elevator Door Speed Controller


Model DC 2000


Great for heavy lobby doors or when operators require more torque to overcome air pressure

Next best thing to a closed loop

Complete factory support before, during and after installation

One year warranty

CSA Approved
 
For more information about this product, please contact John Reinartz at 610-691-2224 or via email at sales@reynoldselectronics.com.
DC 2000 and A.S.C.

Field voltage is adjustable from 60VDC to 160VDC and 60VDC to 240VDC.

Replaces resistance or reactance type of door speed controllers.

Power input of 120VAC 50/60 Hz single phase.

Armature voltage from zero to 160VDC.

DC output is filtered to reduce inductive noise to the motor to extend brush life.

Open/close switch controls the opening and closing of elevator doors for easier cartop setup of speed controls.

Quick disconnect to minimize field time if the board needs to be replaced.

Works with existing cam setup.

Easy installation.

Functions with permanent magnet motor.

Six speed adjustments - three in opening direction and three in closing direction.

Soft start and nudge for safety.

Dimensions: 12" H x 12" W x 4" D.
 
A.S.C. (Auxiliary Speed Controls)

Increased torque.

Complete duplicate set of speed controls usable at floors with heavy or air pressured doors.

Snap-on connector.
Copyright © 2005 Reynolds & Reynolds Electronics. All rights reserved.