DC 244
Elevator Door Speed Controller


Model DC 244


Complete factory support before, during and after installation

One year warranty
 

Field voltage settings: 160VDC or 255VDC for door operators with higher voltages.

Replaces resistance type of door controllers.

Power input of 120VAC 50/60 Hz single phase.

DC output is filtered to reduce inductive noise to the motor to extend brush life.

Open/close switch controls the opening and closing of elevator doors for easier cartop setup of speed controls.

Quick disconnect to minimize field time if the board needs to be replaced.

Works with existing cam setup.

Easy installation.

Dimensions: 12" H x 12" W x 4" D.
DC 6970
Elevator Door Speed Controller




Complete factory support before,
during and after installation

One year warranty






 
For more information about these products, please contact John Reinartz at 610-691-2224 or via email at sales@reynoldselectronics.com.

Field voltage settings: 105VDC or 160VDC for door operators with lower voltages.

Replaces reactance type of door controllers.

Power input of 120VAC 50/60 Hz single phase.

DC output is filtered to reduce inductive noise to the motor to extend brush life.

DC 6970 has adjustable field voltage and works with field and permanent magnet motors.

Open/close switch controls the opening and closing of elevator doors for easier cartop setup of speed controls.

Quick disconnect to minimize field time if the board needs to be replaced.

Works with existing cam setup.

Easy installation.

Dimensions: 12" H x 12" W x 4" D.
Copyright © 2005 Reynolds & Reynolds Electronics. All rights reserved.